Publicidad
Idiomas disponibles
Idiomas disponibles
SilverCrest SGRS 3.7 C1
• Whilst charging, the integrated light indicator of the face cleansing brush (A) will flash.
• When the battery is fully charged, the light indicator will light up permanently. Unplug the mains
adapter (C) from the power socket and then remove the small plug of the mains adapter (D) from the
charging socket (6).
Example of a cleansing cycle:
•
Wash face, remove any make-up, rinse and dry off.
•
Start cleansing cycle
The recommended time for a cleansing cycle is approx. one minute. You can shorten or
extend this time according to preference. Try not to cleanse the eye area using the face
cleansing brush (A). This can be painful due to their size and the sensitivity of the eye area. To
avoid skin irritation, however, each cleansing cycle should not exceed three minutes. This is
why the face cleansing brush (A) automatically switches off after around three minutes.
The vibration briefly cuts out once after approx. 15 seconds. The vibration cuts out briefly
twice after the first minute. Use these signals to spread out the cleansing cycle evenly over the
different areas of the face.
Initial use
To switch the device on, press the On/Standby button (4). The cleansing cycle will start. Use buttons
(3) and (5) to reduce or increase the vibration. There are eight vibration levels available. The last level
you select will be restarted in the next cleansing cycle.
To stop the cleansing cycle and switch off the device, press the On/Standby button (4) again.
22 - English
Publicidad
