Publicidad
Idiomas disponibles
Idiomas disponibles
E-9
MOUNTING THE CD-ROM DRIVE
Step
1. Turn off and
unplug
your
com-
puter
and all
peripheral
devices
attached
to
it.
Step
2. Remove
the
cover
from
your
computer.
Step
3. Remove the front
panel
from
an
unused
half-height
slot.
Step
4. Slide the CD-ROM drive into the
half-height
slot,
and
secure
the
drive in
place
with
screws
and
brackets.
Note: If
there
is
too
much
space
between the sides of the drive and
the drive
bay,
you may need
to
install spacer
brackets,
available
at
your local
computer
store.
Step
5. Push
the
power
supply
cable
connector
firmly
into the power
in
connector.
Figure
6.
Removing
the
Floppy
Disk
Drive and the
Blanking plate
Figure
7.
Mounting
the Drive
Power
supply
connector
(4-pin
connection
cable)
Figure
8.
Connecting
the Power
Supply
Cable
GND
Pin
assignment
The
pin assignment
of the
power-in
connector
is
as
follows:
12V DC
5V DC
CRD-8322
eng
9/20/88
3:00
PM
Page
9
Publicidad
