E-11
SOFTWARE SET UP
This section
covers
installation and
setup
for several
operating
systems.
Read the
entire section and select the
part
for your
operating
system.
THE SET UP PROCESS
The INSTALL program
performs
the
following
functions.
*
Allows the
user
to
select the
target
disk drive where CD-ROM device driver files
will be
set-up.
*
Unless modified
by
the user, the INSTALL program searches the
target
disk for
directory(\CDROM);
if it is
not
found,
the
directory(\CDROM)
is created.
*
Copies
the CD-ROM device driver file named
GSCDROM.SYS,
the Microsoft CD-ROM
Extension file named
MSCDEX.EXE,
and the
utility
files
to
the
specified directory.
*
Modifies your CONFIG.SYS file
to
list the location and
name
of the device driver.
*
Modifies your AUTOEXEC.BAT file
to
load MSCDEX.
*
Terminates and
returns
control
to
the
user.
LIST OF FILES TO BE INSTALLED IN YOUR PC
MSCDEX.EXE
Microsoft MS-DOS CD-ROM Extension
software,
which
enables the
computer
to
access
the CD-ROM drive.
GSCDROM.SYS
CD-ROM device driver.
EJECT.EXE
Software
eject
program which
can
eject
the CD
tray.
CLOSE.EXE
Software close program which
can
close the CD
tray.
RUNNING THE INSTALL PROGRAM
(DOS INSTALLATION)
Step
1. Insert the CD-ROM device driver install diskette into the
appropriate
drive.
Step
2. Go to the
floppy
drive
by typing
A:
or
B:
at
the DOS
prompt,
as
appropriate.
Step
3.
Type
the word INSTALL and press
[ENTER].
Step
4. The INSTALL
program will
begin loading.
When
loading
is
complete,
the
INSTALL program identification will appear
on
the
screen.
Step.5.
Follow the instructions
on
the
screen.
Step
6. If
you
specify
the
path
information
during
the
installation,
the install program will
copy the CD-ROM device driver file named
GSCDROM.SYS,
the Microsoft
CD-ROM Extension file named MSCDEX.EXE and the
utility
files
to
the
specified
directory,
and
modify
your CONFIG.SYS file and AUTOEXEC.BAT file.
Step
7. When the installation is
completed,
remove
the
diskette,
and reboot your PC.
CRD-8322
eng
9/20/88
3:00
PM
Page
11