LG CRD-8322B Manual De Usuario página 7

E-6
HARDWARE
INSTALLATION
This section describes how
to
install your CD-ROM drive into your
computer.
Note: If you
are
not comfortable about opening your PC and attempting the CD-ROM
drive
installation,
many local
computer
shops
can
perform
this service for
a
reasonable
cost.
This installation
assumes
you have
a
PC with
an
available connector
on an
IDE
interface cable. If your PC has
an
IDE hard drive, there is
usually
an
available
connector in the middle of the
same
cable that attaches from the motherboard
(or
controller card) IDE connector to the hard drive. If the last sentence does not describe
your
system,
you may need
to purchase
an
IDE controller card
to
install this CD-ROM
drive.
Inspecting
and
knowing
your PC
system
will make your installation easier and
less time
consuming.
A final
note
before installation: The cable
connecting to
your
floppy
disk drive is
not
an
IDE cable. Do not
attempt
to attach the CD-ROM drive to this cable.
If the CD-ROM drive is to be connected to the
same
cable
as
the hard drive, be
sure
that the hard drive is
set
as
master.
Hard drives
can
be
set
as
single,
master, or
slave.
Check your hard drive owner's manual
or
contact
the hard drive manufacturer for
correct jumper settings.
SETTING MASTER / SLAVE JUMPER
*
You will
see
three pairs of pins and
a
jumper (cap) at the back of the CD-ROM drive.
This jumper is used to set the CD-ROM Drive
as a
CSEL, MASTER,
or
SLAVE device
in your PC.
Examples
of how the
jumper
can
be
placed
are
shown in
Figure
3 below.
*
Move the jumper (clip
on one
pair of pins) from its default factory position (SLAVE), to
CSEL
or
MASTER
as
needed
(see
the
following description
for the
setup
that matches
your
system), using
the above
diagram to place
the
jumper.
WARNING:
To
protect
the CD-ROM
Drive,
your
computer,
and
peripheral
devices from
damage,
turn off their power before
installing
the drive.
(rear of CD
-
ROM drive)
Note
:
The jumper is always
placed vertically,
NEVER SIDEWAYS!
CSEL
mode
SLAVE
mode
(default)
MASTER
mode
Figure 3. Setting
MASTER / SLAVE
Jumper
CRD-8322
eng
9/20/88 3:00 PM
Page
6