Assemble As A Blower; Connect The Power Cord; Operation; Start The Machine - GreenWorks BVA803 Manual Del Operador

EN
9.3

ASSEMBLE AS A BLOWER

1. Move the blower tube (4) forward until the notched area
(11) clicks into the slot (12).
2. Put the concentrator nozzle (5) into the blower tube to
lock.
4
5
You can use the concentrator nozzle to increase airflow
in tight areas: flower beds, under decks, etc.
9.4

CONNECT THE POWER CORD

1. Attach the extension cable to the motor housing with the
cord retainer. This prevents accidental removal of the
electrical cable.
2. Connect the female end of the electrical cable into the
receptacle behind the unit.
10

OPERATION

Make sure the blower tube is in position before operation.
10.1

START THE MACHINE

This machine is equipped with a three-way (OFF/ LOW/
HIGH) switch.
1. Push the on/off button forward to reach the low speed.
11
12
NOTE
WARNING
English
2. Push the on/off button forward twice to reach the high
speed.
A
While in mulching mode, the machine must be in high
speed position.
10.2

STOP THE MACHINE

1. Pull back the on/off button to the off position.
10.3

OPERATION TIPS

• Blow around the outer edge of the unwanted materials to
prevent the unwanted materials from scattering.
• Use rakes and brooms to clear the unwanted material
before you blow.
• Make the surfaces wet before you clear the unwanted
material in dusty conditions.
• Look out for children, pets, open windows, and cleaned
cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete work.
10.4

OPERATE AS A MULCHER

1. Hold the machine tightly.
2. Tilt the mulcher tubes (2 - 4 in. or 5 - 10 cm).
3. Use a sweeping action to collect light unwanted
materials.
Make sure that you install and zip the bag.
Use the shoulder strap.
10.5

OPERATE AS A BLOWER

1. Hold the machine tightly.
2. Operate from side to side.
3. Move the machine forward slowly.
4. Keep the collected unwanted materials in front of you.
8
B

IMPORTANT

NOTE
NOTE