Fagor CG-2010 Manual De Instrucciones página 11

not working properly or if it is damaged
in any way. Take it to an authorised
Technical Assistance Service to be
examined, repaired or modified.
• In the event of technical failure or
improper working, switch the machine
off and do not try to repair it. Repairs
should only be carried out by an
authorised Technical Assistance Service.
Always demand the use of original spare
parts.
• If you decide never to use the appliance
again, it is a good idea to cut the cable,
first ensuring that the appliance is
unplugged.
The liquid that drips into the jug is
hot and may cause burns if the jug is
accidentally broken. To avoid breakage,
take the following safety precautions:
• Do not allow all the liquid to evaporate.
Do not heat the jug when empty.
• Do not use a broken jug or a jug whose
handle is loose or weak. Replace if any
signs of damage are detected. A tiny
crack or breakage of a small piece of the
glass may cause the jug to shatter and
to contaminate the liquid with splinters
of glass.
• Do not clean the jug with an abrasive
scourer or any cleaning products that
may scratch or otherwise weaken the
glass.
• The jug is designed for use with this
appliance. Do not place it on or near hot
surfaces (heaters, burners, hobs, hot
ovens, microwaves, etc.).
• Do not place the jug on wet or cold
surfaces.
• Handle gently and avoid knocking.
• This appliance should not be used
by physically, sensorially or mentally
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance by
a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
4. BEFORE USING FOR
THE FIRST TIME
• Before using for the first time, familiarise
yourself with all the components. Read
all instructions carefully.
• Remove the filter holder (6) and wash
it together with the carafe (8) and the
permanent filter (3) in warm soapy water.
Rinse and dry them well and then fit
them back onto the coffee-maker. To
correctly fit the filter holder (6), hold
it vertically above the anti-drip valve
support (4) with the handle in vertical
position, and place the filter holder (6) in
the space in the anti-drip valve support
(4) (Fig. 2). Then turn the filter holder
handle (6) to horizontal position, and
correctly insert it onto the pins in the
anti-drip valve support (4) (Fig. 2, 3). The
carafe (8) must not be standing on the
warming plate (9) when you assemble
the coffee-maker.
• To clean the inside of the appliance,
run a coffee-making cycle twice without
adding ground coffee to the filter. To do
this, follow the instructions given in the
section entitled "Making coffee".
5. MAKING COFFEE
With the appliance unplugged:
• Place the coffeemaker on a flat, stable
surface.
• Open the deposit lid (1) and make sure
that the deposit is empty. Fill with clean,
cold water to the required level. Do not
exceed the indicated maximum level
mark.
• Make sure the carafe lid opens the anti-
drip valve (5), as otherwise the filtered
coffee will not drip down into the carafe
and the filter will overflow. Remove
and replace the carafe to observe the
difference.
• Stand the carafe (8) on the warming
plate (9).
• Fill the filter (3) with the required quantity
of ground coffee and close the lid.
We recommend one dessertspoon of
10