Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTION
The welding equipment is equipped with power voltage compensation set. When power voltage fluctuates
between±15% of rated voltage, it still works normally.
When using long cable, in order to minimize the reduce of voltage, big section cable is suggested. If the cable is
too long, it will affect the performance of arcing and other system function, so stated length is suggested.
1. Make sure the intake of the machine is not covered or blocked to prevent the malfunction of the cooling
system.
2. Use earth cable that the section no less than 6mm
the connection in the back of the machine to the earth set, or make sure the earth end of power switch
reaches the earth. Both ways can be used for better security.
MIG-160A, MIG-180A AND MIG-200A INSTALLATION：
1) Connect the gas flask with CO2 decompression flow meter and the CO2 mouth behind the machine via gas
cable.
2) Insert the swift plug of earth cable into the swift socket in the front panel.
3) Set the wire wheel with wire on the wheel axis, the
wheel hole should be matched with the wheel fixer.
4) Choose wire slot according to wire size.
5) Loosen the screw of wire-pressing wheel, pit the wire
into slot via wire-lead tube, tune the wire-pressing wheel
to fix wire from gliding, but pressure should be suitable
in case the wire distorts and affects wire sending.
6) Wire roll should turn clockwise rotation to let out wire,
to prevent wire from gliding, wire is usually set to the
fixed hole on the wheel side. To prevent the bent wire
from getting stuck, please cut off this part of the wire.
7) Put and tighten the torch on the output socket and put
the wire into the torch by hand.
2
to connect the housing and earth, the method is from
MIG-160A Installation:
POWER SUPPLY
(1 PHASE~220V)
ELECTRODE HOLDER
CO
METER
2
GAS
CYLINDER
EARTH CLAMP
WORK PIECE
Publicidad
