Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTION
MIG-160A, MIG-180A AND MIG-200A
1） Connect the plugs of two ends of the main loop cable to the switch of the machine body and wire machine
separately and tighten.
2） Connect the air plugs of two ends of the control loop cable to the switch of the machine body and wire
machine separately and tighten.
3） Fix one end of the gas pipe to the CO
4） Insert the swift plug of earth cable into the swift socket in the front panel tighten, the earth cable clincher
nips the work piece reliably.
5） Set the wire wheel with wire on the wheel axis.
6） Choose wire slot according to wire size.
7） Put down the pressure arm, put the wire into slot via wire-lead tube, tune the wire-pressing wheel to fix wire
from gliding, but pressure should be should be suitable in case the wire distorts and affects wire sending.
8） Wire roll should turn clockwise rotation to let out wire; To prevent wire from gliding, wire is usually set to
the fixed hole on the wheel side. To prevent the bent wire from getting stuck, please cut off this part of the
wire.
9） Put and tighten the torch on the output socket, and put the wire into the torch by hand.
10) The machine can use PULL MIG TORCH for welding. Please follow the installation instruction of the PULL
MIG TORCH sketch and the manual instruction to check up.
11) Connect the power cable to the electric case of the relevant voltage grade according to input voltage grade.
Make sure no match mistake and the difference of supplied voltage is among the range of permission.
Installation：
meter, the other to the gas mouth of the wire machine.
2
Publicidad
