Royal Catering RCSL 1/6A Manual De Instrucciones página 37

3) Replacing the Cover:
After filling the tank, install the top cover onto the bowl. Make sure the lid is properly
attached to ensure safe and effective operation of the machine while preparing your
drink.
3.5. Control panel operation
Model RCSL 1/6A (single cylinder machine)
Engine speed display (single cylinder machine)
Activating the motor speed display: Press the clean key ("CLEAN/-") to enter
•
cleaning mode. Then press the setting key ("SET") to display the real-time speed
value on the screen.
Display reading: The left part of the screen displays "--2" and the right part shows
•
the remaining digits. By combining these numbers, you can read the speed of the
main engine, e.g. 2385 rpm.
Setting the gear position (single cylinder machine)
Enter setting mode: Press and hold "SET" key for 2 seconds to enter gear parameter
•
setting mode.
Gear shifting: The left part of the display will flash. Press "SET" key to switch gears
•
(range 1~10).
Saving Settings: If you do not use the keys for 5 seconds, the system will
•
automatically save the set value and exit the setting mode.
Note: The higher the gear number, the lower the temperature of the drink.
Factory settings (single cylinder machine)
Entering Factory Setting Mode: In gear setting mode, press and hold the setting key
•
("SET") for 5 seconds.
Changing parameters: Press the setting key ("SET") to select the parameter to
•
change. Press the cool key ("AUTO/+") to increase the value or the clean key
("CLEAN/-") to decrease the value.
Saving Settings: If you do not use the keys for 10 seconds, the system will
•
automatically save the set values and exit the setting mode.
Factory Parameters Table (Model RCSL 1/6A - Single Cylinder Machine)
Number
F0
F1
F2
F4
EN
Value
80 Gear ratio
1100 Low speed protection value
3 Start protection time
thirty Engine warm-up time
Parameter Name