Royal Catering RCSL 1/6A Manual De Instrucciones página 39

Model RCSL 2/6A (two-cylinder machine)
Engine speed display (two cylinder machine)
Activating the motor speed display: Press the CLEAN key to enter cleaning mode.
•
Then press the setting key ("SET").
Display reading: The left display shows the speed of the left cylinder and the right
•
display shows the speed of the right cylinder. For example, a value of 285 means that
the main engine speed is 2850 rpm.
Setting the gear position (two-cylinder machine)
Enter setting mode: Press and hold "SET" key for 2 seconds to enter left cylinder gear
•
parameter setting mode.
Gear Shift: Press "SET" key to switch to right cylinder settings. Use the add "+" or
•
subtract "-" keys to change the value (range 1~10).
Saving Settings: If you do not use the keys for 5 seconds, the system will
•
automatically save the set value and exit the setting mode.
Note: The higher the gear number, the lower the temperature of the drink.
Factory settings (two-cylinder machine)
Entering Factory Setting Mode: In gear setting mode, press and hold the setting key
•
for 5 seconds to enter factory setting mode.
Changing Parameters: Press the "SET" setting key to select the parameter to change.
•
Use the add "+" or subtract "-" keys to change the value.
Saving Settings: If you do not use the keys for 10 seconds, the system will
•
automatically save the set values and exit the setting mode.
Factory parameters table (Model RCSL 2/6A - two-cylinder machine)
Number
F0
F1
F2
F3
F4
Description of Alarm Codes
3) "- -": Displays when the motor does not run or the motor speed cannot be detected.
The motor and mixer stop working.
4) "NL": Displays when the motor fails or the temperature of the drink is too high,
causing heavy load on the motor and the speed drops below the set value. The motor
and mixer stop working.
EN
Value
80 Left cylinder gear ratio
80 Right cylinder gear ratio
1100 Low speed protection value
3 Start protection time
thirty Engine warm-up time
Parameter Name