Installation Procedure - JVC KW-Z1000W Guia De Inicio Rapido

Monitor con receptor
Ocultar thumbs Ver también para KW-Z1000W:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connection/Installation
=
~
!
Ñ

Installation procedure

1) To prevent a short circuit, remove the key
from the ignition and disconnect the ¤
terminal of the battery.
2) Remove the vehicle parts for installing the
unit and connecting wires to terminal.
3) Make the proper input and output wire
connections for each unit.
4) Connect the speaker wires of the wiring
harness.
5) Connect wiring harness wires in the following
order; ground, battery, ignition.
6) Determine the height of the display unit and
position of the slider. See Distance between
the display unit and the main unit (P.25).
7) Connect the wiring harness connector to the
unit.
8) Install the main unit to the vehicle.
9) Reinstall the vehicle parts.
10) Install the display unit.
11) Reconnect the ¤ terminal of the battery.
12) Perform the Initial Setup.
See Initial SETUP (P.7).
24
(Ø3 x 6 mm)
(Black)
x1
x2
x1

Publicidad

Tabla de contenido
loading

Tabla de contenido