Dreame Z10 Station Manual Del Usuario página 11

appliance has a polarized plug (one blade is wider than the other).
EN
This plug will fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not change the plug
in any way.
Caution:
This device complies with Part 15 of the FCC Rules / Innovation,
Science and Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two conditions:
1. this device may not cause harmful interference.
2. this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following.
Read operator's manual
For indoor use only
time-lag miniature fuse-link
where T15A is the symbol for the time/current characteristic
Direct current
Alternating current
3
Product Overview
Accessories
1. Multi-Surface Brush
2. Dust-Removal Hub
3. Base
4. Soft Roller Brush
5. Extension Rod
6. Soft Dusting Brush
7. Combination Tool
8. Dust Collection Bag
(x1 pre-installed, x1 stored in the
packaging box)
9. Motorized Mini-Brush
10. Accessory Mount
11. Accessory Bag (Screw * 1 + Hex Key * 1)
Fig. A-1
Component Names
1. Display Screen
2. Dust Cup
3. Dust Cup Vent
4. Dust Cup Release Button
5. Multi-Surface Brush
6.
Power Button
(Press to turn on/Release to turn off)
7. Battery Status Indicator
8. Antistatic Contact
9. Battery Pack Release Button
10. Charging Contacts
11. Extension Rod Release Button
12. Extension Rod
13. Brush Release Button
Fig. A-2
Note: The illustrations in this manual are
indicative only. The actual product may
differ.
Dust-Removal Hub
1. Dust Collection Button
Dust Collection Status Indicator
• Solid Green
The dust-removal hub is in standby
mode
• Blinking Green
The dust-removal hub is prepared to
collect dust
• Solid Orange
The dust collection bag uninstalled or
inappropriately installed
• Blinking Orange
The dust collection bag reaches capacity /
the air duct is blocked
2. Dust Collection Bag
3. Magnetic Cover
4. Dust-Removal Hub Vent
5. Charging Contacts
6. Dust Cabinet Filter
7. Air Outlet Filter
8. Power Cord
Fig. A-3
Installation
Dust-Removal Hub Installation
Assemble dust-removal hub onto the base,
and use the hex key in the accessory bag
to tighten the screw.
Fig. B-1
Accessories Installation
Click
Fig. B-2
Note:
• It is not recommended to use the
motorized mini-brush with the extension
rod.
• Please install the accessories according
to the actual cleaning needs.
Charging
Charging with the Dust-Removal
Hub
Note:
• After the plug is connected to the power
outlet, turn on the switch on the back of
the dust-removal hub (1: ON/0: OFF) to
start charging.
EN
4