Publicidad
Idiomas disponibles
Idiomas disponibles
• Fully charge the vacuum before using it
EN
for the first time.
• The vacuum cannot be used while
charging. This will take about 3.5 hours.
• Vacuuming at Turbo mode for a
prolonged period will cause the battery
to heat up, which increases charging
time. Allow the vacuum to cool down for
30 minutes before charging it.
• When the vacuum is not in use, it can be
placed on the dust-removal hub.
• The outlet of the power cord can be
adjusted according to users' needs.
Fig. C-1
Battery Status Display
Display Screen
The number on the display screen
represents the current battery level in a
percentage during charging. When the
number becomes 100, the battery is fully
charged.
Fig. C-2
Battery Status Indicator
Charging
Fully charged
Charging
Discharging
Battery Level ≥ 10%
Battery Level ＜ 10%
Solid white
Blinking white
Fig. C-3
How to Use
Display Screen
1. Trigger Switch Lock
Press briefly to enter/ exit the lock state.
2. Suction Level
The color of fan-shaped icon changes
with different modes.
3. Lock Status
4. Battery Level Percentage
5
When the display shows "LO", it indicates
that the battery level is lower than 10%.
5. Suction Level Switch
Press briefly to switch between eco, med
and turbo mode.
Note: The Med mode is used by default
every time the vacuum is turned on.
Charging/Battery Level Indicator
Low Battery Level
Blinking red: Battery level ≤ 10%
Out of Battery
Blinking red: Battery level ＝ 0%
Charging
Breathing red: Battery level ≤ 10%
Breathing green: Battery level ＞ 10%
Fig. D-1
Suction Level
Med
Eco
Turbo
Fig. D-2
Standby Mode
Off
Troubleshooting
If the vacuum is not working properly, the screen display will show an error message.
Please refer to the troubleshooting table to find your solution.
Error Icon
Status
Error Message
Blinking orange
Air duct blocked
Blinking orange
Brush roller stuck
Solid orange
Filter is expiring
High-
Blinking red
temperature
alert
If one of the error codes from E0 to E4 appears on the display screen, please contact the
after-sales service team.
Working Methods
Select from two working methods for the vacuum, which can be selected based on your
own needs.
Method 1: Discontinuous Cleaning Mode
Press and hold the power button to start the appliance, and release the button to stop
immediately.
Fig. D-3
Method 2: Continuous Cleaning Mode (Trigger Switch Lock)
Press the trigger switch lock to switch to Continuous Cleaning Mode, and then briefly
press the power button to keep the vacuum in Continuous Cleaning Mode.
Note:
• Use the trigger switch lock to free your fingers from fatigue caused by holding the
switch.
• Press the trigger switch lock again to quit Continuous Cleaning Mode.
Fig. D-4
Solutions
Check whether the dust cup,
extension rod, multi-surface brush,
soft roller brush or motorized mini-
brush is blocked.
Refer to the [Cleaning the Multi-
Surface Brush] section to clean the
debris and hair tangled on the brush
roller.
Please replace the filter in time.
Please wait until the motor
temperature returns normal.
EN
6
Publicidad
