Kemper CleanAirTower Instrucciones De Servicio página 86

Pos. Designation
1 Dust collection container
3 Seal
To do so, proceed as follows:
1. Switch off the product using the on/off switch and wait until the
illuminated ring on the on/off switch stops flashing completely.
2. Disconnect the product from the power supply by pulling out the mains
plug and secure against unintentional restarting.
3. Lift the dust collection container (Pos. 1) slightly (A) until it releases from
the magnet holder (Pos. 2).
4. Pull out the underside of the dust collection container (Pos. 1) far
enough (B) so that it can be pulled down (C) on the magnet holder (Pos.
2). Then remove to the rear (D).
5. Close the opening to the dust collection container (Pos. 3) with the
attached sticker (Pos. 4), which is located on the dust collection
container.
6. Reinsert the new dust collection container in reverse order. Please
ensure that the seal (Pos. 3) on the dust collection container (Pos. 1) is
1502828-04
Fig. 35: Changing the dust collection container
Tab. 22: Changing the dust collection container
Pos. Designation
2 Magnet holder
4 Sticker to close the dust
collection container
- 86 -
EN