OPERATING INSTRUCTIONS
APP DECLARATION
Applicable system: Android and Apple iOS
• The app is not compatible with software versions below 4.4 Android and 9.0 iOS.
• Due to the variables involved in your specific installation, we must advise that not all Android and iOS
operating systems will be compatible with the wireless app. We cannot be responsible for any issues
resulting from incompatibility.
Wireless Safety Strategy
The wireless application only supports WPA-PSK/WPA2-PSK encryption. WPA-PSK/WPA2-PSK encryption
is recommended.
Cautions
• Due to different network situations, control processes might sometimes return a time out error. If this
occurrs, unplug the appliance and plug it back in. If it does not automatically reconnect, you may need
to reconnect the appliance to the app.
• Your smart device camera requires at least 5 million pixels to be able to scan a QR code.
• The wireless app is subject to updates without prior notice for functional improvement. The actual
network connection process may be slightly different than outlined in the manual. The actual process
shall prevail.
DECLARATION OF CONFORMITY
Contains FCC ID: 2ADQOMDNA21
Contains IC: 12575A-MDNA21
This device complies with Part 15 of the FCC Rules and it contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference;
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
Only operate the device in accordance with the instructions supplied. Changes or modifications to this
unit not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human
proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
10