Medion LIFE SM60 Manual De Instrucciones página 228

228
10.12. Butt onholes
TIP
To determine the correct stitch length, we recommend sewing a test but-
tonhole on a scrap of fabric.
Presser foot: .............................................................................. Buttonhole presser foot
Programme: ................................................................................. Buttonhole programs
Stitch length: ............................................................................................................... to 
Set the foot and needle to their highest position.
Replace the foot with the buttonhole presser foot.
Please read section ".. Removing and fitting the presser foot" on
page  for more information.
Using a pencil or tailor's chalk, mark the place on the fabric where you
want to sew the buttonhole and mark the required length of the but-
tonhole.
Line up the buttonhole presser foot with the slide at the rear end of the
buttonhole.
Pass the upper thread through the opening on the buttonhole presser
foot and pull both the upper thread and bobbin thread to the left-hand
side.
10.12.1. Procedure
Select the program for the left bar on the program selection dial.
Lower the foot and sew slowly until the bar is the required length.
Raise the needle to its highest position and switch to the program for
the bottom bar.
Sew a few stitches of the bottom bar.
Raise the needle to its highest position again and switch to the pro-
gram for the right-hand bar.
Now sew the right-hand bar exactly the same length as the bar on the
left-hand side.