Maytag Performa LAT2200 Manual Del Usuario página 8

Before You Call (continued)
Won't Spin or Drain
• Unevenly distributed load, Redistribute the load, Close the lid and pull knob out. check for leveling. Be Sure
water !eve! is acceptab!e for !oad Size.
• Check fuse or reset Circuit breaker.
Straighten drain hoses. E!imin ate kinked hoses, If there is a drain restriction, Cal! for Service.
• Close lid and pull knob out to start the washer, For your Safety, washer will not agitate or spin unless the lid is
Closed,
, The washer is equipped with a !id Switch failure detector. !f the !id Switc h Should malfunction, the detector will
stop operations for your safety. Call for service.
• Suds lock = caused by too much Suds. Rewash without detergent. Use Correct amount of a low-sudsing deter,
genL
, Unevenly distributed load. Redistribute the load, close the lid and pull knob out. Check for leveling. Be Sure
water !eve! is acceptab!e f0r !0ad Size.
, Plug Cord int0 !ire e!ectrica! outleL
Check fuse or reset circuit breaker.
• Turn the control knob to proper Cycle and pull knob out to Start the washer.
• Close lid and pull knob out to start the washer. For your safety, washer will not agitate or spin unless lid is
closed.
' This may be a pause or Soak period in the Cycle, Whit briefly and it may start.
• _e washer is equipped with a lid Switch failure detector. If the lid Switch should malfunction, the detector will
stoP fi!! 0perati0ns f0r your safety. Ca!! f0r Service:
Is Noisy
• Be Sure washer is leveled properly as Outlined in installation manual.
' Weak fl0ors can Cause yibration and walking.
Be Sure robber feet are instal!ed on leveling legs.
• IM A clicking sound may be the LoadSensor i agitator as it moves the !oad down through the cleaning zone for
maximum Cleaning effectivness. This sound wi!! vary from !oad to load. This is norma!.
, Operat_g S0_ds wi!! vary depend_g on agitation Speed,