Transporting Your Washer; Reinstalling/Using Washer Again - Kenmore 110.26132410 Manual De Uso

CLEANING YOUR DISPENSER
You may find laundry product residue left over in your dispenser
drawer� To remove residue, follow this recommended cleaning
procedure:
1. Pull drawer out until you feel resistance�
2. Push 1 tab downward, then continue pulling out�
3. Wash in warm, soapy water, using a mild detergent�
4. Rinse with warm water�
5. Air dry or dry with a towel, then place back into slot�
IMPORTANT: Dispenser drawer and tray are not dishwasher
safe�
WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer
where it will not freeze� Because some water may stay in
hoses, freezing can damage washer� If storing or moving
during freezing weather, winterize your washer�
To winterize washer:
1. Shut off both water faucets. Disconnect and drain water
inlet hoses�
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on Rinse & Spin cycle for about 30 seconds
to mix antifreeze and remaining water.
3. Unplug washer or disconnect power�

TRANSPORTING YOUR WASHER

1. Shut off both water faucets. Disconnect and drain water
inlet hoses�
2. If washer will be moved during freezing weather, follow
"Winter Storage Care" directions before moving�
3. Disconnect drain hose from drain system�
4. Unplug power cord�
5. Place inlet hoses inside washer basket�
6. Drape power cord and drain hose over the console and
secure with masking tape�
7. Place foam packing ring from original shipping materials
back inside washer� If you do not have packing ring, place
heavy blankets or towels into basket opening� Close lid
and place tape over lid and down front of washer� Keep
lid taped until washer is placed in new location� Transport
washer in upright position�

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer�
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses� Reconnect water inlet hoses�
Turn on both water faucets�
2. Plug in washer or reconnect power�
3. Run washer through Bulky/Bedding cycle to clean washer
and remove antifreeze, if used. Use only HE High Efficiency
detergent� Use half the manufacturer's recommended
amount for a medium-size load�
13