Power Settings - SEVERIN MW 7848 Instrucciones De Uso

General operating sequence
∙ Place the food to be heated in a suitable container. Place the container onto the turntable in the oven.
∙ When food is placed in the microwave, it should be covered to prevent it from drying out. Glass or plastic covers
especially designed for use with microwave appliances are available at most kitchenware dealers.
∙ When using the grill, hot-air or any of the combination functions, do not cover the food to be cooked.
∙ When using the grill function, place the grill rack directly on the glass turntable and place the food on the grill rack.
∙ Close the door and set the desired programme.
∙ As the programme is started, the turntable starts to rotate. During operation, the interior light remains on.
∙ If a programme is not started within 5 minutes, the unit will automatically go back to Stand-by mode.
∙ If, during operation, the door is opened or the
the temperature is evenly distributed), the timer and programme functions are automatically suspended. The programme
will automatically resume only after the door is closed again and the
∙ Press twice to interrupt the programme.
∙ 5 beeps indicate that the pre-programmed period has elapsed; at the same time, the interior lighting switches off.
∙ Open the door and remove the container with the food.
∙ In order to achieve an even heat distribution through the food, the container should be set aside for several minutes.
Setting the clock:
Once the unit has been connected to the power supply, the display shows '0:00' and an acoustic signal is heard.
Note: The time display does not start counting, unless the clock has been set. The time setting process can be cancelled by
pressing the key.
The clock must be set when the appliance is connected for the fi rst time, and also if a power failure has reset the clock.
1. Press once or twice to select the 24- or 12-hour display. The display shows 24H or 12H.
2. Turn the rotary control to set the correct hour. The hour must be in the range 0-23 (for 24H) or 1-12 (for 12H).
3. Press . The minute digits start fl ashing.
4. Turn the rotary control to set the correct minutes. The range must be 0-59.
5. Press to fi nish setting the time. The symbol ':' fl ashes and the correct time is shown.
The microwave function
To programme the unit for cooking, the correct mode (microwave), the required power setting and the cooking time must be
selected, before the programme sequence can be started. The power setting is selected by repeatedly pressing
cooking time can be pre-set to a maximum of 95 minutes.
Power (P)
1 x 900 W
2 x 720 W
3 x 450 W
4 x 270 W
5 x 90 W
Example: to programme the microwave function for a cooking time of 5 minutes at 50 % power.
1. Press 3 times. The display shows P 50 and
2. Press to confi rm the microwave function.
3. Turn the rotary control until the display shows 5:00.
4. Press . The symbol
Note: The following steps are used for setting the cooking time:
0 – 1 minute : 5-second steps
1 – 5 minutes : 10-second steps
5 – 10 minutes : 30-second steps
10 – 30 minutes : 1-minute steps
30 – 95 minutes : 5-minute steps
22
key is pressed (e.g. to stir or to turn the food in order to ensure that

Power settings

Display
P100 (100 %)
P 80 (80 %) Medium high
P 50 (50 %) Medium
P 30 (30 %) Defrosting
P 10 (10 %)
starts fl ashing on the display.
key is pressed.
Type
High Heating up liquids, cooking
Defrosting and heating up deep-frozen dishes
Cooking delicate food
Defrosting
Low Defrosting delicate food
.
. The