SEVERIN MW 7848 Instrucciones De Uso página 26

A-10
chicken / poultry
Setting multiple programmes
The unit may be set for a maximum of 2 programmes running consecutively, e.g. defrosting, followed by microwave cooking.
Any defrosting, microwave, grill or hot-air programmes as well as the combination of the programmes may be selected. Any
defrosting programme must of course run before any cooking programme can be started.
Example: to defrost food before it is cooked using the microwave function.
1. Programme the defrost function (without pressing
2. Programme the microwave function.
3. Pre ss . The display shows the appropriate symbols for the selected programmes.
5 beeps indicate that the entire programme has fi nished.
Hint: This memory function is especially helpful when using the microwave to cook food at different power settings. While a
higher power setting is selected initially, the power can be reduced at a later stage in order to keep the food hot, and
to ensure that the heat is evenly distributed when the food is already done.
Timer
The microwave can be pre-programmed in such a way that it starts operating at a pre-determined time. However, always
check fi rst that the time on the unit has been correctly set prior to using the timer delay function.
1. Set the time (see Setting the clock).
2. Set the desired programme. The unit allows you to set 2 programmes; however, none of the defrosting programmes
can be selected with the timer delay.
Note: Do not yet press
individually.
3. Press . The current time is displayed and the hour display fl ashes.
4. Use the rotary control to select the desired hour setting (between 0-23 resp. 1-12) at which you want the unit to start
operating.
5. Press . The minute display fl ashes.
6. Use the rotary control to select the desired minute setting (between 0-59) at which you want the unit to start operating.
7. Press . The selected programme will start at the pre-programmed time, when 2 acoustic signals will be heard.
Childproof safety device:
This safety device prevents children from operating the appliance without supervision.
To activate the safety device, press
To switch off the safety device, press
Note: Should you experience a problem switching the appliance on, fi rst verify that the safety device is not activated.
26
after the current programme selection. Automatic cooking programmes can only be started
for 3 seconds. The symbol
again for 3 seconds. The symbol
500 g
750 g
1000 g
1200 g
)
appears on the display.
500
750
1000
1200
disappears.