Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
NetWork Timeout
The network timeout sets the time delay for the Net-X II to stop receiving commands from a console
connected to the network. This can only be applied to HTP/LTP DMX merge modes via Art-Net™ or sACN
protocols.
1.
Use the knob to select 5. NetWork Timeout.
2.
Press the knob.
3.
Use the knob to select either 1. Disabled, 2. 1 Seconds, 3. 2 Seconds, or 4. 5 Seconds.
4.
Press the knob.
5.
5. Exit (to cancel).
If set to Disabled, the Net-X II will remain locked into the network lighting controller even
if the controller stops sending data.
On Source Loss
This option is used to determine what happens when a console suddenly stops sending data to or through
the Net-X II. To configure this setting, follow the instructions below:
1.
Use the knob to select 6. On Source Loss.
2.
Press the knob.
3.
Use the knob to select from 1. Hold output (holds the last value received), 2. Blackout (sets all
DMX channels to a value of 000), 3. Stop DMX (disables the port), or 4. Exit (to cancel).
4.
Press the knob.
Set DMX Port
The Net-X II has 8 DMX ports that can be set as outputs or inputs. To select a DMX port to configure,
follow the instructions below:
1.
Use the knob to select 7. Set DMX Port.
2.
Press the knob.
3.
Use the knob to select the desired DMX port, from DMX Port 1–8 / DMX Input A–B (DMX inputs
will only display if Operating Mode is set to 2 + 8 Port), or Exit (to cancel).
4.
Press the knob.
Disp Type
The display type determines whether the selected port universe displays as either decimal or hexidecimal
values. The display type will alter the menu options for Network and Universe ranges.
1.
Select the DMX port to configure as instructed in
2.
Use the knob to select 1. Disp Type.
3.
Press the knob.
4.
Use the knob to select either DEC (decimal) or HEX (hexadecimal).
5.
Press the knob.
DMX Status
The DMX status determines whether the selected port functions as an input, an output, or is disabled. The
selected status will alter the menu options for DMX Mode and Universe merging.
1.
Select the DMX port to configure as instructed in
2.
Use the knob to select 2. DMX Status.
3.
Press the knob.
4.
Use the knob to select the desired port mode from, DISABLE, OUTPUT, or INPUT.
5.
Press the knob.
Net-X II User Manual Rev. 6
Set DMX
Port.
Set DMX
Port.
15
Publicidad
Tabla de contenido
