Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
1st Universe
Sets the primary Input/Output universe.
1.
Select the DMX port to configure as instructed in
2.
Use the knob to select 7. 1st Universe.
3.
Press the knob.
4.
Use the knob to select from range options (differs based on Disp Type and Protocol selections):
•
000–255: When Disp Type is set to DEC & Protocol is set to ArtNet.
•
001–256: When Disp Type is set to DEC & Protocol is set to sACN.
•
00H–7FH: When Disp Type is set to HEX & Protocol is set to ArtNet.
•
01H–80H: When Disp Type is set to HEX & Protocol is set to sACN.
5.
Press the knob.
LCD Backlight
To set the amount of time after inactivity before the display backlight turns off, follow the instructions below:
1.
Use the knob to select 8. LCD Backlight.
2.
Press the knob.
3.
Use the knob to select from the following options, 1. On (does not turn off), 2. 10 Seconds (turns
off after 10 seconds of inactivity), 3. 30 Seconds (turns off after 30 seconds of inactivity), or 4.
Exit (to cancel).
4.
Press the knob.
User Preset
This option saves 4 different preset menu option configurations. To set these presets, follow the
instructions below:
1.
Use the knob to select 9. User Preset.
2.
Press the knob.
3.
Use the knob to select one of the four following presets:
•
1. Art-net 8-port DMX (Sets all 8 ports to receive 8 universes of Art-Net™ from 0–7).
•
2. sACN to 8-port DMX (Sets all 8 ports to receive 8 universes of sACN from 1–8).
•
3. 1x8 DMX Splitter (Sets the product to operate as a DMX splitter with all 8 outputs
receiving DMX from input A).
•
4. 2x4 DMX Splitter (Sets 1–4 outputs to input-port A and the 5–8 outputs to input-port B).
•
5. Exit (to cancel).
4.
Press the knob.
When using the DMX splitter presets, DO NOT connect a network to the product.
Net-X II User Manual Rev. 6
Set DMX
Port.
17
Publicidad
Tabla de contenido
