Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Factory Reset
To restore the Net-X II to factory default settings, do the follow:
1.
Use the knob to select 10. Factory Reset.
2.
Press the knob.
3.
Use the knob to select NO (do not reset) or YES (reset to factory settings).
4.
Press the knob.
This will erase any existing recorded scenes.
Record Scenes
The Net-X II has the capability to record up to 10 scenes. To record scenes, follow the instructions below:
1.
Use the knob to select 11. Record Scenes.
2.
Press the knob.
3.
Use the knob to select from Scene 1–10.
4.
Press the knob.
Scene Name
The Net-X II allows you to customize the name of each scene. To name a scene, do the following:
1.
Select the Scene to configure as instructed in
2.
Use the knob to select 1. Name:Scene_1–10.
3.
Press the knob.
4.
Use the knob to select the letter, number or symbol, from A–@. There are 96 options.
5.
Repeat until the name is set as desired.
6.
Use the knob to select either Enter to save the name, or Cancel to exit without saving.
7.
Press the knob.
Scene Steps
This feature displays the amount of steps saved to the scene. To view previously saved steps, follow the
instructions below:
1.
Select the Scene to configure as instructed in
2.
Use the knob to select 2. Step:(0/0).
3.
Press the knob.
4.
Turn the knob to cycle through the saved steps.
Add Step
This function adds a step to the scene. To add a step to the scene, do the following:
1.
Select the Scene to configure as instructed in
2.
Use the knob to select Add Step.
3.
Press the knob.
Delete Step
This function deletes a step from the scene. To delete a step from the scene, follow the instructions below:
1.
Select the Scene to configure as instructed in
2.
Use the knob to select Delete Step.
3.
Press the knob.
Timing
This function sets the intervals between steps, as well as a fading effect if desired.
1.
Select the Scene to configure as instructed in
2.
Use the knob to select 5. Timing.
3.
Press the knob.
4.
Use the knob to select:
•
2. Fade In Time:0.10S—9M59S.
•
Press the knob.
•
3. Fade Out Time:0.10S—9M59S.
•
Press the knob.
•
4. Delay Time:0.10—9M59S.
•
Press the knob.
•
5. Exit (to cancel).
5.
Select 1. Save Step menu option to save timing settings.
18
Record
Scenes.
Record
Scenes.
Record
Scenes.
Record
Scenes.
Record
Scenes.
Net-X II User Manual Rev. 6
Operation
Publicidad
Tabla de contenido
