Air Compressor Maintenance; Maintenance Prompts; Maintenance Chart - Ingersoll Rand R4-11 kW Manual Del Usuario

„ Maintenance Prompts
The service warning and flashing LED will appear at intervals dependent
on the service level selected. Refer to the Product Information manual for
information about service level settings.
Period Action
Check
Check
Daily
Check
Check
Check
Inspect
Monthly
Inspect
Inspect
Every 1000 hours
Analysis
Inspect
Inspect
Inspect
Inspect
Replace
Every 2000 hours or
3 months
Replace
Replace
Replace
Analysis
Analysis
Inspect
Replace
Every 4000 hours or
Clean
6 months
Calibrate
Replace
Every 6000 hours
Replace
Replace
Every 8000 hours or
annually
Replace
Replace
16000 hours or 2 years
Replace
Replace
24000 hours or 3 years
Replace
40000 hours or 5 years Replace
Inspect and replace air filtration, coolant and separator elements more frequently in dirty operating environments
80448517 Rev A
RELEASED 16/Dec/2014 10:49:53 GMT

AIR COMPRESSOR MAINTENANCE

„ Maintenance Chart
Maintenance should be performed per the recommendations below in the
following priority: (1) Perform maintenance when indicated by the controller;
(2) Perform maintenance through either hourly intervals or scheduled
maintenance intervals, or (3) Annually.
Table 2: Maintenance Chart
Maintenance Item
Connections and hoses for leaks
Coolant level
Condensate drain operation
Controller for service indicators
Package pre-filter for blockage
Air-cooled combination cooling system for blockage
Starter box power drive element (PDM) filter element (if applicable)
Air filter element
Food-grade Lubricant (Ultra FG)
Starter box power drive element (PDM) filter element (if applicable)
Drive belt
Airend/Pressure System/Receiver
Inspect and test pressure relief valve
Air filter element
Package pre-filter element
Separator element
Coolant filter element
Shock pulse bearing
Premium Coolant (Ultra/Ultra EL)
Scavenge tubes/orifice and blowdown orifice for blockage
Starter box power drive element (PDM) filter element (if applicable)
Air-cooled combination cooling system
Pressure transducers (only applies to compressors equipped with Xe-70M controller)
Dryer filter elements (if applicable)
Food-grade Lubricant (Ultra FG)
Premium Coolant (Ultra) [8000 hours or every 2 years]"
Minimum pressure check valve (MPCV)
Drive belts
Extended Life Premium Coolant (Ultra EL) [16000 hours or every 3 years]"
Rubber Coolant Hoses
Contact tips
Stainless Steel Coolant Hoses
NOTICE
EN
EN-3