Kicker KX.1 Serie Manual Del Propietário página 11

Ocultar thumbs Ver también para KX.1 Serie:

Tabla de contenido

Idiomas disponibles



around the ampliﬁ er.

engaged. Voltage to the ampliﬁ er is not within the 10–16 volt operating range. Have the vehicle's charging

and electrical system inspected.

is engaged. Check for speaker wires shorted to each other or to the vehicle chassis. Check for damaged

speakers or speaker(s) operating below the minimum recommended impedance.



No or low output?

and speaker output connections.

Alternator noise-whining sound with engine's RPM?



input) cable

Check the routing of RCA (or speaker input) cable



grounding

Check the gain settings and turn them down if they are set too high.

Ground Noise? KICKER ampliﬁ ers are engineered to be fully compatible with all manufacturers' head

units. Some head units may require additional grounding to prevent noise from entering the audio signal. If

you are experiencing this problem with your head unit, in most cases running a ground wire from the RCA

outputs on the head unit to the chassis will remedy this issue.

KXARC Troubleshooting: If the KXARC LEDs ﬂ ash three times, it is not currently connected to an

amp. Press the pairing button on the back of the remote and on the KXA amp for 1 second. NOTE: If the

KXARC is not active or in sleep mode, it will not show as connected on the KXA panel. If the KXARC will

not power on, replace the battery.

CAUTION: When jump starting the vehicle, be sure that connections made with jumper cables are

correct. Improper connections can result in blown ampliﬁ er fuses as well as the failure of other critical

systems in the vehicle.

If you have more questions about the installation or operation of your new KICKER product, see the

Authorized KICKER Dealer where you made your purchase. For more advice on installation, click on the

SUPPORT tab on the KICKER homepage, www.kicker.com. Choose the TECHNICAL SUPPORT tab,

choose the subject you are interested in, and then download or view the corresponding information.

Please E-mail support@kicker.com or call Technical Services (405) 624-8583 for unanswered or speciﬁ c

questions.

2017 KXA Mono Amps Rev H.indd 11

Ampliﬁ er shuts down only while vehicle is running = voltage protection circuitry is



Ampliﬁ er will only play at low volume levels = short circuit protection

Check the balance control on source unit



If using a Low-Level signal, make sure Radio Detect is OFF.

KXA400.1

200 x 1 @ 4 ohms, 14.4VDC, 1% THD, CEA-2006B (Watts)