Troubleshooting - Flotec FP0S2600X Manual Del Usuario

English
FP0S2600X
Ref. Description
1 Lower Base Plate
2 Impeller
3 Upper Base Plate
4 Motor
5 Power Cord
6 #8 Screw x .75"
• Garden Hose Adapter
* Purchase locally
** If motor fails, replace entire pump.
• Not Illustrated.

Troubleshooting

Symptom Possible Cause(s)
Blown fuse
Low line voltage
Pump won't start
or run
Defective motor
Impeller
Low line voltage
Something caught in impeller
Small diameter garden hose or
Pump operates but
long discharge line
delivers little or no
Check valve installed without
water
vent hole
Air lock
Coils or bends in hose
For parts or assistance, call Flotec Customer Service at
Qty. Part No.
1 FP0005797A
1 PS5-24P
1 FP0005796A
1 **
1 PS117-54-TSU
*
1 FT0013-43
Corrective Action
If blown, replace with fuse of proper size.
If voltage under recommended minimum, check size of wiring
from main switch on property. If OK, contact power comapany.
Replace pump.
If impeller won't turn, remove lower base plate. Locate source
of binding.
Use only 14 gauge or larger extension cords. Use short
extension cords when necessary.
Clean out impeller.
Use larger diameter garden or 1" flexible pipe. Eliminite any
excess hose. Short hoses work best.
Drill a 1/16" - 1/8" (1.6-3.2mm) dia. hole between pump
discharge and check valve.
Turn off pump for a few seconds, clean out anti-airlock hole
and restart pump.
Straighten hose.
5
4
3
2
1
6
230 0394a
800-365-6832
4