Settings - Festool CT 36 E AC Manual De Instrucciones

The antistatic system
Friction inside the extraction hose causes static
electricity to develop during extraction. Operating
personnel may receive unpleasant electric shocks
Consider the pictures on the fold-out page.
Connecting electric power tools
WARNING
Risk of injury

Observe the maximum appliance socket con-
nected load (see chapter "Technical data")

Switch off the electric power tool.

Connect the electric power tool to the appliance
socket [1-3].
Connecting pneumatic tools
WARNING
Risk of injury

Make sure that the pneumatic tool is switched
off before connecting or disconnecting.
If the compressed air module [1-2] (496141) is in-
stalled, the automatic switch-on function of the
mobile dust extractor also works in combination
with pneumatic tools.
We also recommend installing the VE service unit
(495886). The service unit filters and lubricates the
compressed air and enables an adjustment of the
while working. The mobile dust extractor is fitted
with an antistatic system as standard to discharge
any static electricity that may develop. However, al-
ways use the enclosed antistatic extraction hose.

Settings

air pressure. An IAS adapter (454757) is available to
connect Festool pneumatic tools to the IAS system.
The operating pressure of the tool must be 6 bar for
the automatic switch-on unit to function correctly.
Temperature cut-out
To prevent overheating, a temperature cut-out
switches the mobile dust extractor off when it
reaches a critical temperature.

Switch off the mobile dust extractor and allow to
cool for about 5 minutes.
 If the mobile dust extractor will not switch on
again, please contact a Festool service work-
shop.
Adjusting the suction power
You can use the suction power adjuster [1-8] to
adapt the machine suction power to different appli-
cations.
AUTOClean - Cleaning the main filter
To maintain a constant suction power when extract-
ing fine dust, you can adjust the frequency of the
automatic [1-7] cleaning system in infinite vari-
ables using the rotary knob. Always use the auto-
matic cleaning system in combination with a dis-
posal bag.
Before performing wet extraction tasks or
working with a filter bag, set the [1-7] rotary
knob to position 0.

Set the automatic cleaning function to the high-
est setting when [1-7] extracting large quanti-
ties of dust.
Manual cleaning
If the suction power decreases, cleaning can
be started manually by turning the switch
[1-9] to the AC symbol positioned on either
side of the switch.
11