SEVERIN KA-4150 Instrucciones De Uso página 11

Setting the time
Insert the plug into a suitable wall outlet.
None of the indicator lights will come on. The
coffee maker is switched off, the LCD display
showing 0:00.
The internal clock uses a 24-hour display
format. The current time is set by using the
'H' button for the hours, while the 'M' button
is used to set the minutes.
Example:
The current time is 15.30 (3 pm).
∙ Press the 'H' button repeatedly (or keep it
pressed for the necessary length of time)
until the LCD display shows 15:00.
∙ Press the 'M' button (or keep it pressed)
until the LCD display shows 15:30.
Timer
To start the brewing process with a delayed
timer setting, the timer must be set to the
desired time.
∙ Press the button 'PROG' and keep it
pressed. The LCD display shows- BREW
and the time last entered, or 0:00.
∙ While the PROG button is pressed, the
desired time can be set using the buttons
'H' und 'M'.
Afterwards, press the On/Off button once.
The red indicator light AUTO comes on
and the LCD display shows AUTO. At the
pre-programmed time, the coffee maker will
automatically switch on.
On/Off button (I/0)
The On/Off button is used to switch between
the three settings 0-AUTO-I:
0 - The appliance is switched off.
No indicator light is on.
AUTO - The appliance automatically
switches on at the pre-
programmed time. The red AUTO
indicator light comes on and the
LCD display shows AUTO.
I - The appliance is switched on. The
green indicator light I comes on.
Before using for the fi rst time
Before making coffee for the fi rst time,
let the appliance go through two or three
fi ltration cycles using the indicated maximum
amount of cold water, but without using
ground coffee. This should also be done
if the appliance has not been used for an
extended period of time, and after descaling.
General information
∙ A measuring scale on the water container
and on the glass carafe facilitates fi lling
the container with the correct amount
of clean water. With a dual-scale, the
left scale is used for regular-sized cups
of approx.125ml, while the right scale is
used for smaller cups. Make sure that the
indicated maximum amount of water is not
exceeded.
∙ If several consecutive brewing cycles
are required, switch off the coffee maker
after each cycle and let the appliance cool
down for approx. 5 minutes.
∙ Important note: When fi lling the
appliance with fresh water shortly after
a brewing cycle is completed, there is a
danger of scalding from hot water or steam
escaping through the water outlet.
Making coffee
∙ Filling with water:
Open the water container lid, fi ll the
container with the desired quantity of water
and replace the lid.
∙ Inserting the paper fi lter:
11