Radio Reception - Sony XAV-602BT Manual De Instrucciones

Stored stations and correct time are erased.
The fuse has blown.
The unit makes a noise when the position of the
ignition is switched.
 The leads are not matched correctly with the car's
accessory power connector.
The display disappears from/does not appear on
the monitor.
 The dimmer is set to [ON] (page 25).
 The display disappears if you press and hold OFF.
 Press OFF on the unit until the display appears.
 The monitor off function is activated (page 5).
 Touch anywhere on the display to turn the
display back on.
The display does not respond to your touch
correctly.
 Touch one part of the display at a time. If two or
more parts are touched simultaneously, the
display will not operate correctly.
 Calibrate the touch panel of the display
(page 23).
 Touch the pressure sensitive panel firmly.
The Auto OFF function does not operate.
 The Auto OFF function activates when no source
is selected.
 Exit the source.
Menu items cannot be selected.
 Unavailable menu items are displayed in gray.
USB Music, USB Video, AUX and BT Audio cannot
be selected as the source.
 Remove the check mark from the source item you
cannot select (page 27).
The notification panel does not appear.
 The notification panel is not available when the
unit is;
 at the initial settings.
 displaying the source in a popup.
 under the voice command function.
 receiving TA.
 playing back USB Video.
The playback controls does not appear in the
notification panel.
 The playback controls are not available when the
unit is playing back content from the following
sources;
 AUX
 USB Video
 application on a smartphone via the App
Remote function

Radio reception

The stations cannot be received.
The sound is hampered by noises.
 The connection is not correct.
 Connect a power antenna (aerial) control lead
(blue) or accessory power supply lead (red) to
the power supply lead of the car's antenna
(aerial) booster (only when your car has built-in
radio antenna (aerial) in the rear/side glass).
 Check the connection of the car antenna
(aerial).
 If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
Seek starts after a few seconds of listening.
 The station is non-TP or has weak signal.
 Deactivate TA (page 11).
There are no traffic announcements.
 Activate TA (page 11).
 The station does not broadcast any traffic
announcements despite being TP.
 Tune in another station.
PTY displays [PTY not found.].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program type.
The program service name flashes.
 There is no alternative frequency for the current
station.
 Touch / while the program service
name is flashing. [PI seek] appears and the unit
starts searching for another frequency with the
same PI (Program Identification) data.
Picture
There is no picture/picture noise occurs.
 A connection has not been made correctly.
 Check the connection between this unit and
other equipment, and set the input selector of
the equipment to the source corresponding to
this unit.
 The disc is defective or dirty.
 Installation is not correct.
 Install the unit at an angle of less than 45° in a
sturdy part of the car.
 The parking cord (light green) is not connected to
the parking brake switch cord, or the parking
brake is not applied.
 Activate the video output of the iPod.
37
GB