Presentation; Of The Line; Of The Instrument - Chauvin Arnoux MiniFLEX MA200 Manual De Instrucciones

1.1. OF THE LINE

MiniFLEX series MA100 sensors constitute a line of 3 standard models that can be
used to convert alternating current from 0.5 to 3000 A into proportional alternating
voltages.
These probes are intended in particular for the viewing of alternating currents, to
determine transition and propagation times in electrotechnical equipment.
Each sensor takes the form of a flexible coil, 17, 25 or 35 cm long, connected by
a shielded cord to a small housing containing the signal processing electronics,
supplied by a battery.
The flexibility of the sensors makes it easier to wrap them round the conductor to
be measured, whatever its type (cable, bar, strand, etc.) and its accessibility. The
design of the snap‑action coil opening and closing device allows it to be handled
while wearing protective gloves.
The housing can be connected to any oscilloscope having an AC voltage input and
an input impedance of at least 1MW.

1.2. OF THE INSTRUMENT

Flexible sensor.
Sensor
opening
device.
Shielded cord.

1. PRESENTATION

19
BNC cord for connection
to a display device.
Green ON/OFF
indicator.
3‑position
slide switch.