Waeco SinePower MSP 702 Instrucciones De Uso página 51

SinePower
11.1 Set energy saving mode (Standby)
In energy saving mode, the inverter does not release any voltage, thereby
preserving the battery. If a connected appliance requires power which is
more than the pre-set power value, the inverter reverts to normal operation.
You can switch to energy-saving mode using the DIP switches S1, S2 and
S3 (fig. 3 1, page 4) and set the power value.
The switch positions for your inverter can be found in the following table:
Energy-saving mode up to
MSP 702
MSP 704
Off
15 W
25 W
40 W
50 W
65 W
75 W
85 W
11.2 Switch between 50 Hz and 60 Hz.
The output voltage can be switched between 50 Hz and 60 Hz with the DIP
switch S4 (fig. 3 1, page 4).
WARNING! Danger of electrocution!
!
Only adjust the S4 DIP switch when the respective frequency for
the output voltage should be used.
Set the S4 DIP switch (fig. 3 1, page 4) according to the following table:
Output voltage frequency
50 Hz
60 Hz
EN
MSP 1012 MSP 2012
MSP 1024 MSP 2024
MSP 1512 MSP 2512
MSP 1524 MSP 2524
Off
20 W 40 W
40 W 80 W
55 W 125 W
75 W 170 W
95 W 210 W
115 W 245 W
135 W 280 W
S1
Off Off
On
Off
On
Off
On
Off
On
S4 DIP switch
On
Using the inverter
DIP switch
S2 S3
Off Off
Off Off
On Off
On Off
Off On
Off On
On On
On On
Off
51