Description (Fig. A); Package Contents (Fig. B & C); Assembly (Fig. D); Fasten Nuts And Bolts - Tunturi C25 Manual Del Usuario

Description (fig. A)

Your Crosstrainer is a piece of stationary fitness
equipment used to simulate cycling without causing
excessive pressure to the joints.
Package contents (fig. B & C)
- The package contains the parts as shown in
fig. B.
- The package contains the fasteners as shown in fig.
C. Refer to the section "Description"
NOTE
• If a part is missing, contact your dealer.

Assembly (fig. D)

WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least two
persons.
CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around the
equipment.
• Refer to the illustrations for the correct assembly
of the equipment.
NOTE
• Save the tools provided with this product, after
you completed the product assembly,
for future service purposes.

Fasten Nuts and Bolts

Securely tighten all Nuts and
Bolts after all
components have been
assembled in current and
previous steps.
NOTE: Do not over tighten any component with
pivoting function. Make sure all pivoting components
are able to move freely.

Workouts

The workout must be suitably light, but of long
duration. Aerobic exercise is based on improving
the body's maximum oxygen uptake, which in turn
improves endurance and fitness. You should perspire,
but you should not get out of breath during the
workout.
To reach and maintain a basic fitness level, exercise at
least three times a week, 30 minutes at a time. Increase
the number of exercise sessions to improve your fitness
level. It is worthwhile to combine regular exercise with
a healthy diet. A person committed to dieting should
exercise daily, at first 30 minutes or less at a time,
gradually increasing the daily workout time to one hour.
Start your workout at low speed and low resistance to
prevent the cardiovascular system from being subjected
to excessive strain.
As the fitness level improves, speed and resistance can
be increased gradually. The efficiency of your exercise
can be measured by monitoring your heart rate and
your pulse rate.
Pulse rate measurement
(hand pulse sensors)
The pulse rate is measured by sensors in the handlebars
when the user is touching both sensors at the same
time. Accurate pulse measurement requires that the
skin is slightly moist and constantly touching the hand
pulse sensors.
If the skin is too dry or too moist, the pulse rate
measurement will become less accurate.
NOTE
• Do not use the hand pulse sensors in
combination with a heart rate chest belt.
• If you set a heart rate limit for your workout, an
alarm will sound when it is exceeded.
Heart rate measurement
(heart rate chest belt)
The most accurate heart rate measurement is achieved
with a heart rate chest belt. The heart rate is measured
by a heart rate receiver in combination with a heart rate
transmitter belt. Accurate heart measurement requires
that the electrodes on the transmitter belt are slight
moist and constantly touching the skin. If the electrodes
are too dry or too moist, the heart rate measurement
will become less accurate.
1 9
Do not tighten all Nuts and Bolts
in this step.
English