Console (Fig F); Explanation Of Buttons; Explanation Display Functions - Tunturi C25 Manual Del Usuario

Console (fig F)

1
2
3
1. Display
2. Tablet/ book support
3. Buttons
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
NOTE
• The console switches to standby mode when
the equipment is not used for 4 minutes. If the
console is in standby mode, the display shows
the room temperature

Explanation of buttons

Up (Dail)
- Press UP Key to increase value. Press and hold the
key to increase value faster.
- TIME setting range: 00:00~99:00 (Each increment is
1:00)
- CAL setting range: 0~9990 (Each increment is 10)
- DIST setting range: 0.00~99.50 (Each increment is
0.5)
- PULSE setting range: 0-30~230 (Each increment is
1)
Down (Dail)
- Press DOWN Key to decrease value. Press and hold
the key to decrease the value faster.
- TIME setting range: 00:00~99:00 (Each decrement
is 1:00)
- CAL setting range: 0~9990 (Each decrement is 10)
- DIST setting range: 0.00~99.50 (Each decrement is
0.5)
- PULSE setting range: 0-30~230 (Each decrement is
1)
Mode/ Enter
- Choose each function by pressing MODE/ENTER
key.
- Press and hold MODE/ENTER key for 2 seconds to
reset all functions (same feature as the reset key if
press for 2 seconds).
Reset
- In setting mode, press RESET key once to reset the
current function figures.
- Press RESET key and hold for 2 seconds to reset all
function figures
Recovery
- After the console detects pulse signal, press the
RECOVERY key to enter recovery mode to monitor
heart rate recovery ability
Body Fat
- Test body fat% and BMI.
Total reset
- Console will restart over.

Explanation Display functions

Scan
- In SCAN mode, press MODE/ENTER key to choose
functions.
- Automatically scan through each mode in sequence
every 6 seconds.
- The sequence of display when press MODE/ENTER
key : TIME » DIST » CAL » PULSE » RPM/SPEED
Speed
- Range 0.0 ~ 99.9
- Without any signal being transmitted into the
monitor for 4 seconds during workout, SPEED will
display "0.0"
RPM
- Range 0 ~ 999
- Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM will
display "0"
2 1
English