Intended Use - DeWalt DWD450 Manual De Instrucciones

• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
i_,WARNING: Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other
injury. Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body.
WARNING: Always wear proper personal hearing protection
that conforms to ANSI $12.6 ($3.19) during use. Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V................... volts A ...................... amperes
Hz ................. hertz
min ............... minutes
.... or DC... direct current
(_) ................. Class I Construction
(grounded)
[] ................. Class II Construction
(double insulated)
.../min .......... per minute
BPM ............. beats per minute
IPM ............... impacts per minute
RPM ............. revolutions per
minute
W. .................... watts
"_ or AC .......... alternating
current
or AC/DC... altemating
or direct
current
no .................... no load
speed
n ...................... rated
speed
@..................... earthing
terminal
sfpm ............. surface feet A ..................... safety alert
per minute symbol
SPM ............. strokes per minute
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking. Voltage
decrease of more than 10% will cause loss of power and overheating.
DEWALT tools are factory tested; if this tool does not operate, check
power supply.
COMPONENTS (Fig. 1, 5)
A WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Bail handle
B. Speed selector lever
C. Forward/reverse button
D. Trigger switch
E. Bail handle bolt
INTENDED USE
R 1/2" (13 mm) keyed chuck
G. E-Clutch
TM
indicator
(DWD460)
H. Knuckle guard (DWD460)
I. Side handle (two positions)
The DWD450 and DWD460 heavy-duty stud and joist drills are
designed for professional drilling at various work sites (i.e., construction
sites). DO NOT use under wet conditions or in presence of flammable
liquids or gases.
These heavy-duty stud and joist drills are professional power tools.
DO NOT let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.