Kenwood CMOS-300 Manual De Instrucciones página 14

Display View Switching (CMOS-300 only)
Display View Switching
The CMOS-300 camera system can display 5 kinds of
camera images.
1
With an image displayed on the monitor, press
the view button of the switch unit.
Each press switches the image display mode in the
following order.
Super Wide View
Wide-angle image covering a horizontal angle of
about 190°.
Wide View
Camera image covering a horizontal angle of about
135°.
Overhead View
Image seen from the viewpoint straight up above
the vehicle.
14
|
CMOS-300/CMOS-200
PinP View
The overhead view is displayed on the upper half
of the screen while the wide view is displayed on
the lower half. The overhead view in the upper half
of the screen shows the area on the nearer side
of the orange line shown in the wide view in the
lower half.
Corner View
The views seen from the two corners of vehicle are
displayed on the left and right halves of the screen.