Kenwood CMOS-300 Manual De Instrucciones página 5

10
Adjust the camera angle so that the rear part of
the vehicle or the rear bumper is visible at the
bottom of the monitor screen.
Vehicle rear part or bumper
When adjusting the camera angle, be careful not to
stretch the camera cord.
11
After adjusting the camera angle, tighten the
retaining screws fi rmly.
Inspect the retaining screws at times. If they are
loose, tighten them fi rmly.
12
Perform the operations in "Camera Setting"
(page 8). (CMOS-300 only)
If an adjustment is not possible in the currently
available range, change the camera position before
retrying.
13
Fix the camera fi rmly in position.
Peel off the paper liner from the double-side
adhesive tape on the camera bracket and attach it.
After attaching, push the camera bracket with your
fi nger to ensure close adhesion.
Do not touch the adhesive surface with your hand
or peel and reattach an attached tape, as these
will degrade the adhesive force and may cause the
camera bracket to be detached. If required, secure
the bracket on the vehicle body using the camera
bracket clamping screw.
Camera bracket clamping screw
Installing the Power Supply Box
1
Attach double-side adhesive tape on the power
supply box and then attach it under the carpet
on the front passenger seat side.
Do not attach the power supply box in the
following place.
- Place moistened by water.
- Unstable surface.
- Place that comes in the way of driving.
- Under high temperature.
Installing the Switch Unit (CMOS-300
only)
1
Clean the switch unit installation surface.
Using a commercially available cleaner, wipe dirt,
moisture and oil away from the surface on which
the switch unit is to be attached.
2
Attach double-side adhesive tape on the
bottom of the switch unit and then attach it in
an easy-to-operate position, for example near
the dashboard on the driver seat side.
|
English
5