Kenmore 665.1304 Manual De Uso Y Cuidado página 19

DelayHours (onsome models)
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak
hours when possible.
To delay the start
1. Select a wash cycle and options.
2. Press the delay button.
3. Press START/RESUME.
NOTE= Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again, to resume the
delay countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCI< ON is lit, all buttons are
disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on the Lock
Press and hold CONTROL LOCI< for 3 seconds. LOCI< ON will light up. If you press any pad while your dishwasher is locked,
the light flashes 3 times and an audible tone will sound.
NOTE: The dishwasher cannot start if the control is locked.
To turn off the Lock
Press and hold CONTROL LOCI< for 3 seconds. The light turns off.
Status Indicator Lights
D slc wasl< ÷ " FeedbcJck Sec
The status lights on top of control will inform you if the dishwasher is sanitized and/or
complete. The lights on the control panel will turn blue while washing or rinsing, red while
drying, and green when complete.
Selecting Cycles and Options
1. Select the desired cycle. If you want to run the last cycle that was completed, you can simply press START once to show
which options you used, then press START again to start the cycle.
2. Select the desired options. Not all options are available for every cycle. If an invalid option is selected for a given cycle,
the lights will flash.
Turning OFF/ON the Sound
Press and hold HIGH TEMP for 3 seconds to toggle sound ON and OFF. The sound will not be deactivated for cycle interrupt
or service required messages.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door,
2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up.
3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the
dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.
(_,;Ba_'_g _"_g A ......_ _J s_'w'ss_° e_ '_ '_ - _ s _':_" ,:_d
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before
restarting your new cycle.
3. Press Cancel/Drain twice to reset the control.
4. Select new cycles and options.
5. Press START/RESUME. 19