Kenmore 665.1304 Manual De Uso Y Cuidado página 22

TROUBLESHOOTING
CHECK THESE POINTS TO HELP SAVE YOU TIME AND MONEY.
PROBLEM iSOLUTION
DISHWASHER DOES
NOT RUN
NOTE: It is normal for the dishwasher to repeatedly pause several times during a cycle.
If the Start/Resume light is blinking, close the door and push START/RESUME.
Be sure the door is closed and latched.
Check that there is not an interference with large casserole dishes and the wash system at
the back of the dishwasher. Adjust loading as necessary to ensure door is closed and
latched.
Be sure you have selected a cycle. (See "Cycles and Options Information.")
Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
If lights other than Start/Resume blink and the unit will not run, you will need to call for
service.
DETERGENT REMAINS IN
THE DISPENSER OR
TABLET IS ON BOTTOM
OF TUB
Check for dishware such as cookie sheets, cutting boards, or large containers, etc., that may
be blocking the detergent dispenser from opening properly.
Be sure your detergent is fresh and lump free.
Be sure the cycle has completed (green or blue light is on). If it has not completed, you will
need to resume the cycle by closing the door and pressing START/RESUME.
CYCLE RUNS TOO LONG NOTES:
• To use less water and reduce energy consumption you will encounter cycles that
typically run for up to 3 hours.
• A water heater setting of 120°F (49°C) is besh the dishwasher will delay longer while
heating cooler water.
• Some options will add time to the cycle. (See "Cycles and Options Information" section.)
The Heated Dry option adds 1/2 hour.
Try the 1 Hour Wash cycle.
Run the hot water at a faucet close to the dishwasher before starting the cycle.
DISHWASHER NOT DRYING
NOTE: Plastic and items with nonstick surfaces are difficult to dry because they have a
porous surface which tends to collect water droplets. Towel drying may be necessary.
Use of rinse aid along with the Heated Dry option is needed for proper drying.
Proper loading of items can affect drying. (See specific loading instructions within this
guide.)
Glasses and cups with concave bottoms hold water. This water may spill onto other items
when unloading.
• Unload the bottom rack first.
• Locate these items on the more slanted side of the rack for improved results.
WILL NOT FILL Be sure the water is turned on to the dishwasher.
Check that the float is free from obstructions. (See "Parts and Features.")
Check for suds in the dishwasher. If foam or suds are detected, the dishwasher may not
operate properly or may not fill with water.
22