Yamaha 40 Manual De Instalación página 18

7. Check:
• Throttle operation
Unsmooth operation → Adjust.
Checking steps:
• Turn the shift lever to the neutral position.
• Fully open and close the throttle several
times.
• Check that the throttle valve fully opens
and closes.
8. Connect:
• Wiring harness coupler 1
NOTE:
Fit the wiring harness in the clamp a.
9. Install:
• Fitting plate 1
• Bolts 2
NOTE:
After secure the fitting plate, lift the tiller handle
straight up and check that the cables and wires
are not stretched.
Bolt:
8.0 N • m (0.82 kgf • m, 5.9 ft • lb)
9
E