Maintenance; Troubleshooting - DeVilbiss Healthcare VacuAide 7310 Serie Manual De Instrucciones

MAintenAnCe & trOuBLeshOOting

mAInTEnAnCE

Changing Filter & Replacing Canister
1. Change the bacteria filter every 1 to 2 months OR immediately if overflow occurs.
2. Remove the bacteria filter by disconnecting it from the suction unit and lid assembly.
3. Replace it with a new DeVilbiss bacteria filter # 7305D-608 (12 pack).
NOTE
–Verify clear side of filter marked <In> faces canister.
NOTE
– Use only the bacteria filter provided by DeVilbiss Healthcare or one of its Distributors.
Substitution may lead to contamination of the unit and/or poor performance and will
void warranty.
4. Replace Collection Canister every 1 to 2 months, depending on use and cleaning method.

TRoUblESHooTInG

NOTE
– Before you contact your equipment provider, follow Troubleshooting below:
Electric shock hazard. Do not attempt to open or remove cabinet, there are no
user-serviceable internal components. If service is required, return the suction
unit to a qualified DeVilbiss provider or authorized service center. Opening or
tampering with the unit will void the warranty.
NOTE
– If problem is not resolved, contact your authorized equipment provider.
Problem
Unit does not power on. (Green external
power indicator should be illuminated
when power is applied.)
Pump runs, but no vacuum.
Low vacuum.
Battery will not hold a charge.
�dAnger
Action
1. Check power sources and connections.
2. Ensure wall outlet is live by plugging in a lamp.
3. Check that battery is fully charged.
1. Check that all tubing is connected properly.
2. Check tubing connections for breaks, leaks, or
occlusions.
3. Ensure that float shut-off is not activated due to
full bottle.
4. Check for leaks or cracks in bottle assembly.
1. Use vacuum adjustment knob to increase vacuum
level.
2. Check system for leaks.
1. Confirm battery is connected (refer to Set-Up).
2. Verify that charge light turns on.
3. Check electrical connections during charging.
4. Ensure wall outlet is live by plugging in a lamp.
If problem continues, contact your equipment
provider.
EN
9
A-7310