Multiplex FunCub Instrucciones De Montaje página 9

Examine your kit carefully!
MULTIPLEX model kits are subject to constant quality checks throughout the production process, and we sincerely hope that you
are completely satisfied with the contents of your kit. However, we would ask you to check all the parts before you start
construction, referring to the Parts List, as we cannot exchange components which you have already modified. If you find any
part is not acceptable for any reason, we will readily correct or exchange it once we have examined the faulty component. Just
send the offending part to our Model Department. Please be sure to include the enclosed complaint form, duly completed. We
are constantly working on improving our models, and for this reason we must reserve the right to change the kit contents in terms
of shape or dimensions of parts, technology, materials and fittings, without prior notification. Please understand that we cannot
entertain claims against us if the kit contents do not agree in every respect with the instructions and the illustrations.
Caution!
Radio-controlled models, and especially model aircraft, are by no means playthings in the usual sense of the term.
Building and operating them safely requires a certain level of technical competence and manual skill, together with
discipline and a responsible attitude at the flying field. Errors and carelessness in building and flying the model can
result in serious personal injury and damage to property. Since we, as manufacturers, have no control over the
construction, maintenance and operation of our products, we are obliged to take this opportunity to point out these
hazards and to emphasise your personal responsibility.
Recommended equipment:
Min. RX-7-light M-Link receiver
or RX-9-DR M-LINK receiver
or RX-7-Synth IPD 35 MHz A-band
alternatively 40 / 41 MHz band
2 Tiny-S servos (rudder, elevator)
2 Nano-S servos (aileron)
Optional: 2 / 3 additional Nano-S servos
(for landing flaps and aero-tow release)
Power set:
"FunCub" power set
including brushless motor, speed controller,
propeller, driver and accessories.
Recommended battery:
Li-BATT eco 3/1-2000 (M6)
Adhesive:
Zacki ELAPOR® 20 g
Zacki ELAPOR® super liquid, 10 g
Tip!
"FunCub" power set, Li-BATT powered
As above, but including Li-BATT eco 3/1-2000 (M6) flight battery
Tools:
Scissors, balsa knife, combination pliers, screwdriver.
Specification:
Wingspan
Overall length
All-up weight
Wing area
Wing loading
RC functions
VE 20
VE 20
1400 mm
980 mm
approx. 1130 g
38 dm²
min. 30 g/dm²
Aileron, rudder, elevator, throttle
Optional landing flaps and aero-tow release
# 21 4243
GB
Order No. 5 5810
Order No. 5 5812
Order No. 5 5880
Order No. 5 5882
Order No. 6 5121
Order No. 6 5120
Order No. 6 5120
Order No. 33 2649
Order No. 15 7231
Order No. 59 2727
Order No. 59 2728
Order No. 33 3649
9