Daily Inspection And Maintenance; Accessories; Disposal; Metal, Electrical And Electronic Parts - Rothenberger PORTACUT 185 Serie Instrucciones De Uso

The correction procedure is also given on the inside of the front cover.
 Install saw blade in order of Fig. D-1 (5.1.1. Replacing the saw blade).
 Install saw blade referring to 5.1.1. Replacing the saw blade.
 Confirm the oblique cutting according to the procedure as described before.
Typ BSP:
 Loosen the bolt (1) and lock nut (2) of flat vice-R (3) and turn the adjustment bolt (4) to ad-
just the angle of the flat vice-R.
 When the blade guide head F side longer: Turn the adjustment bolt clockwise. When the
blade guide head R side longer: Turn the adjustment bolt counter clockwise. One turn of the
adjustment bolt allows adjustment of about 1 mm..
 Measure the amount of the oblique cutting.
5.5

Daily Inspection and Maintenance

 Immediately replace power plug, power cord and extension cord, if damaged.
 Check the saw blade for chipping or damage. Replace if chipping is found. (For the saw
blade replacing procedure, refer to 5.1.1. Replacing the saw blade)
 Check the blade stopper ball bearings and back stopper ball bearings. If they are not set
correctly, cutting accuracy will decline. When the ball bearings are worn, replace them as
soon as possible. (Replace all the bearings on both sides.)
 Check for loose fitting screws of parts. If used loosened, danger can result. Retighten them.
 Completely wipe off dirt and chips from the machine.
 Coat the machine with rust preventive grease when the machine is not used for a long peri-
od of time.
6

Accessories

Accessory Name
Band saw blade, SS, 1640x13x0,65, ZpZ 8
Band saw blade, SS, 1640x13x0,65, ZpZ 10
Band saw blade, SS, 1640x13x0,65, ZpZ 14
Band saw blade,Bi-M,1640x13x0,65, ZpZ 14
Band saw blade, SS, 1640x13x0,65, ZpZ 24
Band saw blade,Bi-M,1640x13x0,65, ZpZ 18
Adjustable pipe support
Spareparts
7

Disposal

7.1

Metal, electrical and electronic parts

Components of the unit are recyclable material and should be put to recycling. For this purpose
registered and certified recycling companies are available. For an environmental friendly dispos-
al of the non-recyclable parts (e.g. electronic waste) please contact your local waste disposal
authority.
For EU countries only:
Do not dispose of electric tools with domestic waste. In accordance with European
Directive 2012/19/EC on waste electrical and electronic equipment and its implementa-
tion as national law, electric tools that are no longer serviceable must be collected
separately and utilised for environmentally compatible recycling.
20
ROTHENBERGER Part Number
No. 56602
No. 56603
No. 56604
No. 56605
No. 56607
No. 56608
No. 56609
www.rothenberger.com
ENGLISH