Restore Channel List And Settings; Save Channel List And Settings - FTE univers U4128 Manual De Usuario

OSD 34
OSD 35
OSD 36
OSD 37
CHANNEL
2. After entering the password correct a safety question will
show up where you have to confi rm fi rst (OSD 35 next page).
3. Select "Yes" to delete all channels or "No" to cancel and
confi rm with [OK].
4. In step 2 and step 3, pressing [Exit] will exit the function
directly without saving.
? FREQUENTLY ASKED QUESTION
Q: IF I incautiously delete all channels, what should I do?
A: There are three ways to restore:
- To re-search all channels at the "Installation" menu.
- Use "Factory Default" function to restore all channels in the
"Tools" menu. The receiver will load the factory channels.
- Use the "Restore channel list and settings" option as next
point shows.

3.6. RESTORE CHANNEL LIST AND SETTINGS

Using this option, the receiver will load the channels saved as
previously as a backup of the user channels list (see point 3.7.).
For restoring the default channels, please:
1. Enter the password. The default password is "0000".
2. After entering the password correct a safety question will
show up where you have to confi rm fi rst (OSD 36).
3. Select "Yes" to delete all channels or "No" to cancel and
confi rm with [OK].
4. In step 2 and step 3, pressing [Exit] will exit the function
directly without saving.

3.7 SAVE CHANNEL LIST AND SETTINGS

This option is very important, because here is where the security
of your data lies. This option makes a backup of the channel
list and it will allow restoring the channel list even thought after
a factory default.
Once you have customized your receiver and everything
operates properly, you have the possibility, with this option, to
save the programs' data.
1. Enter the password. The default password is "0000".
2. After entering the password correct a safety question will
show up where you have to confi rm fi rst (OSD 37).
3. Select "Yes" to delete all channels or "No" to cancel and
confi rm with [OK].
4. In step 2 and step 3, pressing [Exit] will exit the function
directly without saving.
PAG. 23