Osd Setting; Parental Lock - FTE univers U4128 Manual De Usuario

OSD 71
OSD 72
SYSTEM SETUP

5.4. OSD SETTING

When you select "OSD Setting" you will see a screen like
beside (OSD 71):
1. Subtitle Display: Press [
current channel has subtitle information, it will be displayed if
this function is "On". If this function is "Off" subtitles won't be
displayed.
2. OSD Timeout: This setting determines the duration the info
window is displayed on the screen when you change channels.
Press [ ] to set the time between 1 to 10 seconds.
3. Position: To defi ne the position of the information's bar
(top/bottom).
4. OSD Transparency: With this parameter you can set the
transparency of the menus. Press [
between 10%, 20%, 30%, and 40% and "NO" (means no
transparency function).
5. Load OSD Setting Default: If you want to reset your OSD
settings to the default settings then select this item and press
[OK].
6. Press [Exit] button to leave the "OSD Setting" menu.

5.5. PARENTAL LOCK

You can set a password for anyone who wishes to operate
the "Installation" menu. You can also set the password to
lock channels. Below you fi nd how to set and change the
password.
1. On "Parental Lock", press [OK] to open a dialogue box and
input the password. After you entered the correct password,
you will see a screen like beside (OSD 72):
2. Menu Lock: If Menu Lock is set to "Yes" then you need to
enter the password every time you want to open then menu. If
it is set to "No" then you can open the menu without entering
the password fi rst.
3. Channel Lock: If set to "Yes" then you need to enter the
password before you can see those channels which have been
marked as locked channels in the Channel menu. If it is set to
"No" then even those channels can be selected without entering
the password fi rst.
4. New Password: Here you can change the existing password.
You should do this after you set up the receiver the fi rst time
and every time when you think that your password is known
by unauthorized persons. To change the password, enter the
new password in the "New Password" item and repeat the
same one in the "Confi rm Password" item. If the passwords
are not identically then you will see a warning message. If you
entered the same new password in both fi elds then you will see
the message "Saving Data, Please Wait...". From now on you
need to use the new password to open locked menus or locked
channels.
PAG. 32
] to select "On" or "Off". If the
] select the value