Factory Default; Software Upgrade; Upgrade By Satellite - FTE univers U4128 Manual De Usuario

OSD 79
OSD 80
OSD 81
TOOLS

6.3. FACTORY DEFAULT

When you press [OK] on the "Default Value" item:
1. A dialogue box will occur where you need to enter the
password.
2. After you input the correct password a warning message will
be displayed like the one beside (OSD 79).
3. If you select "Yes" then all changes you made will be reset to
default values. Make sure you really want to do this!
4. Press [Exit] in both steps will close the window without
resetting the receiver.

6.4. SOFTWARE UPGRADE

There are two ways of upgrading the software of the receiver as
you can see at OSD 80.

6.4.1. UPGRADE BY SATELLITE

This function can upgrade the software of your receiver through
data sent by a satellite. At the moment we offer satellite updates
only through ASTRA1 satellite.
1. Select the satellite and TP or input the TP value and download
PID.
2. Then mark "Start" and press [Enter] to begin the download
of the upgrade (OSD 81). This may need up to 60 Minutes.
Therefore we suggest using of this function only if you don't
intent to watch TV during this time.
At the moment of writing this manual, the data for the software
upgrade by Satellite is:
•Satellite: Astra
•TP Frequency: 12604 MHz.
•Symbol Rate: 22000
•Polarity: Horizontal
•Download PID: 1277
For changes in the data of the satellite please visit http://www.
universbyfte.com .
PAG. 35