Unpacking And Contents; Unpacking - Erreka MAGIC Manual Del Instalador

UNPACKING AND CONTENTS

1

UNPACKING

1 Open the package and remove the contents from
within.
}
Discard the packaging in an environmentally
friendly manner, using recycling containers.

Do not leave the packaging within the reach
of children or handicapped people, as it may
cause injury.
2
CONTENTS

The following elements are supplied in the MAGIC operator package: operator (5), capacitor (17), release
keys (18) and installation instructions (quick guide). The other elements which appear in the illustration are
supplied separately (adapter kits):
AMA01: set of operator metal fittings for aluminium door
AMA02: set of operator metal fittings for iron door
Fig. 3 MAGIC operator and metal fittings (AMA01 / AMA02)
2 Check the content of the packages (see figure
below).

Should it be noticed that a piece is missing or
deteriorated, contact the nearest technical service.
1 Base plate with pin
2 Bottom mount
3 Countersunk M6 screws (8)
4 Adaptation plate (only models for
iron profile)
5 Operator (MA210F/MAS210F/
MA250F/MAS250F)
6 Countersunk M10 screws (4)
7 Bushing seals (2)
8 Top mount with joint
9 Nuts M8 (2)
10 Angle
11 Upper pin unit
12 Glands
13 Screws M8 (2)
14 Pressure washer M8 (2)
15 Template to make the orifices
16 Water guard
17 Capacitor
MA210, MA210F, MAS210F: 5μF
MA250, MA250F, MAS250F: 8μF
18 Release keys
(only for MA210F/MAS210F and
MA250F/MAS250F)
19 Caps (2)
(only for MA210F/MAS210F and
MA250F/MAS250F)
C249A
MAGIC built-in electromechanical operator
English
47