Operation With The Power Supply Unit; Handling And Use; Improving Battery Service Life; Cutting Hair - Silvercrest SHBS 1000 A1 Instrucciones De Uso

Operation with the power supply unit

♦
♦
♦
GB
MT
♦
♦

Handling and use

Improving battery service life

Cutting hair

Cut length add-ons
♦
♦
50
If your hair and beard trimmer stops working during shaving due to discharged
or weak batteries, you can continue shaving by plugging in the power supply
unit .
6
Plug the power supply unit plug
and beard trimmer.
To avoid injuries and damage to the appliance, always switch the appliance off
before connecting it to the power supply.
Plug the power supply unit
socket complying with the appliance specifi cations.
After 1 - 2 seconds, you can switch the appliance on by pressing the ON / OFF
3
switch . If the appliance does not start immediately, switch it off again and
wait around 1 minute before switching it on again.
If you want to charge the batteries without using the charging station
manner you can only do this when the appliance is switched off .
We recommend completely discharging the batteries before recharging to ensure
a long battery service life. In order to completely discharge the batteries, run the
appliance until it stops completely.
NOTE
► Any hair to be cut should be clean and dry.
► Brush the hair carefully through to remove any knots.
► Place the hairdressing cape or cloth around your neck and throat to avoid
cut hair ends falling inside your collar.
► First start using a longer cut length add-on
stages until it has the required length.
:
7
Select a suitable cut length add-on
mm / 7 - 9 mm / 10 - 12 mm / 16 - 18 mm / 22 - 24 mm / 28 - 30 mm).
Click the selected cut length add-on
Ensure that both pins in the cut length add-on
cutouts in the trimmer head holder.
into the socket on the underside of the hair
6
(wide voltage range 100 - 240 V) in a power
6
and then shorten your hair in
7
to match your required hair length (4 - 6
7
onto the trimmer block
7
correctly locate into the side
7
in this
5
from behind.
SHBS 1000 A1