Installation And Adjustment; Tools; Manner Of Delivery; Mounting Backrest - Vermeiren Inovys II Manual De Instrucciones

EN
NL
3

Installation and adjustment

The instructions in this chapter are for the specialist dealer.
The Vermeiren multi-functional wheelchairs Inovys II has been designed entirely for your
comfort. This wheelchair can be adjusted to individual requirements as explained below.
To find a service facility or specialist dealer near you, contact the nearest Vermeiren facility.
A list of Vermeiren facilities can be found on the last page.
L WARNING:
manual.
L WARNING:
wheelchair (tilt back or sideways).
3.1

Tools

To set up the wheelchair the following tools are needed.

Wrench set n° 10 to n° 22

Allen key set n° 3 to n° 8

Screwdriver Phillips head

Screwdriver

Nipper

Pliers
Assembly and settings may only be performed by a specialist dealer.
3.2

Manner of delivery

The Vermeiren Inovys II shall be delivered with:

1 frame with arm supports, rear and front wheels

1 pair footrests

Seat and back cushions

Tools

Manual

Accessories (optional)
When you receive the wheelchair, please check that the product supplied is complete and fully
functional. Warranty claims are only valid if the manufacturer (supplier) is notified in writing
within a period of two weeks. In the case of any defect that is not immediately evident, warranty
claims are only valid if the manufacturer (supplier) is notified in writing within two weeks after
it is detected. We shall remedy defects in the manner of our choosing - either by carrying out
a repair or by providing a replacement.
3.3

Mounting backrest

L WARNING:
secured.
Risk of unsafe settings - Use only the settings described in this
Variation of allowed adjustments can still change the stability of your
Risk of injury - Make sure that the ring of safety pin Ⓐ is firmly
After you have taken the wheelchair out of the
original packaging, push the backrest to the back
into the 90° position. Guide the safety pins Ⓐ into
the appropriate socket to packaging, push the
backrest to attach the spring Ⓑ, which is located at
the back under the seat.
Check that no cables are squashed.
Page 14
Inovys II
2011-11