Pushing Handles; Mounting Or Removing Backrest; Transfer In And Out The Wheelchair - Vermeiren Inovys II Manual De Instrucciones

2.8

Pushing handles

L CAUTION:
Risk of injury - Make sure that the star buttons  are properly
tightened.
L
CAUTION:
Risk of tipping over - Use only the last indentation of the pushing
handle tube for the maximum height adjustment.
2.9

Mounting or removing backrest

L WARNING:
Risk of injury – Check that the backrest is firmly mounted into the
four brackets before using your wheelchair.
L WARNING:
Risk of injury – Avoid getting your fingers, clothes caught during the
assembly process.

2.10 Transfer in and out the wheelchair

L CAUTION:
In case you cannot perform the transfer in a safe manner, ask
someone to assist you.
L CAUTION:
Risk of tipping over of the wheelchair – Do not stand on the foot
plates.
The pushing handles can be adjusted in height
depending on the size of the attendant.
1. Loosen the star button  located on the
back of the backrest.
2. Pull the pushing handles into the desired
position (7 positions). Indentions  (steps
30 mm) have been placed into the tubing of
the pushing handles.
3. Retighten the star button  firmly by hand.
The backrest of the wheelchair can be mounted
by following instructions.
1. Mount the backrest into the four brackets
+ .
2. Turn on the upper star buttons  to lock the
star buttons by hand.
3. Check that the backrest is firmly fixated.
To remove the backrest of the wheelchair:
1. Loosen the upper star buttons .
2. Pull the backrest upwards out the four
brackets  + .
Page 9
EN
Inovys II
2011-11
NL
