Bosch GSR12V-140FC Instrucciones De Funcionamiento Y Seguridad página 9

Mounting and Removing Adapters
A. Make sure the hex drive 1 is free. Pull out any
bit you might have used.
B. Insert the hex shaft of an adapter into the drive
1 and push the adapter until it snaps in place.
You may need to rotate the adapter a little.
Fig. 3
B
14
Using Right Angle Adapter
You can rotate the right angle adapter 13 to any
position around the axis of the tool in 9° incre-
ments. See Fig. 5.
A. Make sure the adapter is locked on the tool.
Pull the adapter 13 away from the lock ring 14
approximately 3/16" (5mm).
B. Rotate the adapter 13 to a desired position.
C. Release the pull and let the adapter return to
the locked position.
The right angle adapter's interface 13a is iden-
tical to the interface of the power tool. You can
attach the other 3 adapters to it the same way
as the adapters are mounted to the tool (See
"Mounting and Removing Adapters").
2610045267 A5.indd 9
1
A
C
C. Lock the adapter in place by turning the lock
ring 14 in the direction shown until it clicks
(Fig. 3).
To remove any adapter, turn the lock ring 14 in
the direction shown until it clicks. Pull the adapter
away from the tool (Fig. 4).
Fig. 4
14
Fig. 5
x .
m a
B
A
13a
13
m )
5 m
" (
1 6
3 /
14
C
11/23/16 9:49 AM
9